[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: oscillations
Hall D Electronics:
Hi Yves,
Ok thanks for clarifying that. Do you remember also, was the scope then
set for high-Z or 50 Ohm input? This could make a big difference in
provoking the oscillations. Let us know, if you remember it. Thanks,
Gerard
Yves Van Haarlem wrote:
> Hi All,
>
> Just to answer Gerard's question:
>
>> 2. We put on the new preamp and I asked Yves to connect as before.
>> Oscillations were observed. Here are the details of the connection: The
>> signal cable was ~3m, ERNI connector on one end, the other end broken out to
>> 100 (?) Ohm termination resistors on pair #1, 2-9, and 18-25. Pairs 10-17
>> were not terminated. (They are also open on the preamp board end of the
>> cable, since no ASIC or termination resistor is there.) For one of the
>> channels (at a time, we looked at a few) the 100 Ohm resistor termination was
>> removed (Yves, is that right, or did we leave it?) and in it's place two
>
> We left the 100 Ohm termination resistor in.
>
> Cheers,
> Yves