[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
CDC-FDC support rails
Hi All,
The plan is to attach the supporting rail for the FDC/CDC directly to
the inner 8mm aluminum plate of the BCAL. This would be at the 90° and
270° wedges. There would be blind screw holes every 9 inches or so in
the plate. The total weight supported by the rails will be under 1000
lbs (500 lbs ea). This puts the shear stress in the bond joint under 1
psi. The wedges will be supported by the adjacent wedges below. Some
pictures can be seen at:
www.jlab.org/~whitey
under the BCAL tab.
All comments welcome.
Cheers,
Tim
begin:vcard
fn:Timothy Whitlatch, PE
n:Whitlatch;Timothy
tel;work:757-269-5087
tel;fax:757-269-5279
version:2.1
end:vcard