Re: Change of Shipping address

[Elton Smith <elton@jlab.org>]

Hall D Electronics:


HI Fernando,

I am a little confused. Will there be any testing at Alberta?

Thanks, Elton.






Elton Smith
Jefferson Lab MS 12H5
12000 Jefferson Ave
Suite # 16
Newport News, VA 23606
elton@jlab.org
(757) 269-7625

On Thu, 10 May 2007, Fernando J. Barbosa wrote:

> Hi Mitch,
>
>     The BIS-711 export control form has been completed and faxed to Jim
> Cousins at MOSIS.
> The following is a tentative outline of the next steps:
>
> 1.    The chips will be shipped to you for testing.
> 2.    After testing, these will be shipped to Jlab to be assembled onto
> the preamp cards.
> 3.    The preamp cards are being designed at Jlab for further tests on
> the prototype FDC and CDC wire chambers.
> 4.    I will circulate a test spec sheet that we can use for qualifying
> the chips.
>
> Please let me know if there are other steps that need to be considered
> at this time.
>
> Best regards,
> Fernando
>
> Mitch Newcomer wrote:
> >
> > Design   77419  (GAS-1)
> > Fab-ID is T74LAB
> > PO: 0000087100
> >
> > RE>>>>The project will be shipped to:
> >      Dr. J. PINFOLD   C/O SUZETTE CHAN
> >      UNIV. OF ALBERTA CENTRAL RECEIVING
> >      MATERIAL MGT. BUILDING CEB 445
> >      116 STREET & 85 AVENUE
> >      EDMOND AB  T6G 2R3
> >
> >
> > Please ship all 40  parts to the following US address:
> >           Mitch Newcomer
> >           University of Pennsylvania
> >           209 S 33rd St,
> >           Philadelphia, PA  19104
> >               These parts will be bench tested at Penn before assembly
> > on boards
> >
> > Mitch Newcomer.
> >
>