[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
receiver/shaper board conversion for use with GAS-1 & 18m cable
Hall D Electronics:
Hi Fernando,
Much delayed (sorry), I got together the information about the
receiver/shaper board changes. It was delayed a little because I thought
I was getting inconsistent test results (compared to some of my earlier
measurements w/ the preamp board) - but I think I was just confused.
Yves has a board with exactly this setup (except for the termination of
the 8 extra lines). I have another now. I'll send you parts to do
Simon's two boards, okay?
The changes are described, and a new schematic pdf is shown, in the
receiver/shaper board document, GlueX-doc-736-v3.
Thanks,
Gerard