[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: HV board / ASIC



Hi Yves,


Yves Van Haarlem wrote:
> Dear Fernando,
>
> We are slowly reaching towards finalizing the new CDC prototype. We 
> will use the mapping you proposed for the leads on the EDAC connector. 
> Is there any progress on the new HV-board? 
I have not yet finished the design of the HVB, due to other commitments, 
but I expect to complete it next week. Fabrication and assembly will 
follow. I will also include holes for the cable holder, as you requested.
> Another thing which is a little less important would be the 
> availability of another ASIC board with two/three ASIC chips to plug 
> into the HV board. I know, even with 24 armed straws we have not 
> enough shaper and fADC channels to read them out --- at the moment.
I still have a few chips left but I need to order more PCBs. Assembling 
3 chips is a bit tricky, but possible, due to the cover on the ICs. The 
shaper boards only accepts 16 inputs, though.
>
> Just double checking: Is it correct that channels 9-16 are not read 
> out if we use the ASIC board with only two chips (so we have to 
> connect channels 9-16 of the EDAC connector to the least important 
> straws).
Yes, that's correct. The third chip, on the back, would cover channels 
9-16. But the shaper only reads 16 channels and the cable that you have 
has been modified to route channels 1-8 and 17-24 into the 16 channels 
of the shaper.

Have you finalized the gain measurements for the CDC? I need to finalize 
the ASIC specs by next week and will circulate a spec sheet for comments.

Regards,
Fernando



>
> Cheers and thanks,
>     Yves
>
>
>
>                           /--------------------------------
>                          /   Yves Van Haarlem
>        _--~~--_         /
>      /~/_|  |_\~\      /      Carnegie Mellon University
>     |____________|    /        Department of Physics
>     |[][][][][][]|:= /          Wean Hall room 8404
>   __| __         |__ \            Pittsburgh, PA 15213
>  |  ||. |   ==   |  | \           USA
> (|  ||__|   ==   |  |) \
>  |  |[] []  ==   |  |   \           Tel.:   +1 412 268-6949
>  |  |____________|  |    \                  +1 412 641-9252
>  /__\            /__\     \          Fax.: +1 412 681-0648
>   ~~              ~~       \-----------------------------------
begin:vcard
fn:Fernando J. Barbosa
n:Barbosa;Fernando J.
org:Jefferson Lab
adr:Suite #10, 12B3;;12000 Jefferson Ave.;Newport News;VA;23606;USA
tel;work:757-269-7433
version:2.1
end:vcard