[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Technical Design of the Hall D Tagging Spectrometer
Hello Everyone
I put my present draft of the re-written CDR chapter 4 on my web page
and on the wiki.
http://www.jlab.org/~jstewart/PPS_Review08.pdf
http://www.jlab.org/Hall-D/software/wiki/index.php/Tagger_and_Beamline_Review#Material_Prepared_for_the_Review
There is still a lot of work to do but I wanted to distribute what I
have. The first 36 pages are unchanged as this is part of Richard's
writing assignment. The majority of the remainder of the document is
updated.
Here is what I still need to do:
Change the author list to GlueX collaboration.
Chapter 4
I need to discuss the dispersion which is more than our spec.
I need to update figure 4.2
I need to update figure 4.3 and it's caption
I need more information from Pavel on section 4.4.
Mark Wiseman will give me the numbers for table 4.2
Tim and I have to talk to Kelly Mahoney about the PPS and MPS.
Chapter 5
I need the current and voltage from Yang for the coil for table 5.1
I need the length of the focal plane from Yang for table 5.1
I need to add a reference for Yang's nice stress note.
!!! Section 5.3 needs coordinated with Yang and Dan they may re-write it!!!
I need better versions of all figures.
Figure 5.7 uses data from the old two magnet design.
Table 5.2 is only a place holder. It should be replaced with an
updated version. (Dan? Yang?)
I did not change section 5.5
We may want to describe the simulation before the magnet.
Chapter 6
I added this new.
I need to write a introduction section.
I need to move Eq 6.1 into the text and update the numbers with
Tim's Calc.
Figure 6.3 needs updated when slava gets a new model.
Section 6.2.2 will be written by Richard
I do not know what to write for section 6.2.3
Chapter 7
I need to write an introductory section
Figure 7.1 needs updated when chuck gets a new model.
I re-wrote 7.3 but Richard can decide if he wants to keep it.